História stránky

This parameter is not used for the Honeywell C-Bus line. For other line types it has a similar meaning as the "Device ID" parameter on the Honeywell C-Bus line: it is the C-Bus Id assigned to the D2000 KOM process. It must be an unused number between 1 and 30 reserved for the D2000 KOM process on the C-Bus network.

This parameter is not used for the Honeywell C-Bus line. For other line types it has a similar meaning as the "Baud Rate" parameter on the Honeywell C-Bus line: it is the C-Bus baud rate, supported baud rates are 4800, 9600 and 19200 Bd.
Note:
for Line Mode = Direct and a Serial line, the parameter must match the communication speed configured on the line.

Mode of communication with C-Bus:

• ISA card - uses ISA card KMFB02 (obsolete)
• KPX02 - use of KPX02 communication computer
• Direct - direct communication via RS-485 serial interface

The parameter allows "tuning" of time parameters. A positive value decreases the wait before sending a message, a negative value increases the wait. Reducing the wait can compensate for the slowness of the communication computer.

Debugging messages for input data. Parameter is a bit mask, meaning of individual bits is as follows:

• 1.bit - debugging of received data - priority task handling RS-485 interface (for Line Mode = Direct)
• 2.bit - debugging of received packets with correct CRC - priority task handling RS-485 interface (for Line Mode = Direct)
• 3.bit - debugging of received packets with correct CRC - line service task
• 4.bit - debugging of received values - line service task
• 5.bit - debugging of analysed packets - line service task

Debugging messages for output data. Parameter is a bit mask, meaning of individual bits is as follows:

• 1.bit - debugging of sent data - priority task serving RS-485 interface (for Line Mode = Direct)
• 2.bit - debugging of special packets - priority task serving RS-485 interface (for Line Mode = Direct)
• 3.bit - debugging of sent data - line service task
• 4.bit - debugging of composed requests - line service task
• 5.bit - debugging of reading the list of points - line service task