Script debugging - stepping options

The following dialog box appears after selecting the item Settings from the local pop-up menu.

Debug options

Stepping parameters may be configured in the dialog box.

Delay between steps Delay between the execution of individual actions (in the debug mode only) during their continuous execution (the options Continue, Go To End, Go To Line, …).
Show debug messages Shows / hides the current debugging logs when you are debugging. If the parameter is checked, the delay between steps must be greater than 50 [ms]. Debug messages are shown in tab Debug and they are written to log file of D2000 CNF process.
Stop on error (ON ERROR) Enables / disables blocking continuous execution of actions when an error is detected (the state when the ON ERROR handler is activated).
Show all value's attributes It determines the range of displayed information when debugging a local variable. The value of a local variable will be shown if the mouse cursor is pointing at the local variable.

Note

  • Sending the current information during continuous execution of actions may, if the delay between actions is too short, increase the system load.

Related pages:

0 komentárov

Nie ste prihlásený. Akékoľvek zmeny, ktoré vykonáte, sa označia ako anonymné. Ak už máte svoj účet, pravdepodobne sa budete chcieť prihlásiť .