The utility startcli allows users to run and monitor D2000 system processes, which cannot be run and monitored directly by the process D2000 Server. There are two groups of such processes:
- processes which connect to process D2000 Server from another computer (e.g. D2000 KOM, D2000 Calc, D2000 Event Handler, D2000 Alarm,...)
- processes which do not connect to the particular process D2000 Server but to a HOT server in redundant configurations (e.g. D2000 Archiv, D2000 KOM)
The utility StartCli (the file startcli.exe is located in the subdirectory Bin of the installation directory) can be run with the following parameters:
| Declaration | startcli /parameter1 /parameter2 ... /parameterN |
||||||||
| Parameters |
|
||||||||
| Description | The utility startcli may be run as a service (the parameter /X1) or directly from the command prompt (the parameter /X0 or without the parameter /X). After starting, the utility waits few seconds (the parameter /T) and then checks regularly the status of the monitored process in a loop. The monitored process must be a service and its name is given by the parameter /W. If the service is stopped, at first the utility startcli waits the given time (the parameter /F) and then runs the service stopped. | ||||||||
| Note | See also the utility SCS Config |
Related pages:
Pridať komentár