Configuration of communication line of TCP/IP-UDP category.
Line of category TCP/IP-UDP was designed for the needs of communication protocols which are built directly on UDP layer of TCP/IP stack. It enables also implementation of redundant communication (redundant network lines, redundant network interfaces) and configuration of two IP addresses of a communication partner.
Following protocols are supported at the present time:
TCP/IP-UDP line configuration
Primary server - Host
IP address or a network name of a computer. Depending on a specific communication protocol, it may be IP address of a computer where D2000 KOM process is running (in this case a symbolic IP address ALL, representing all network interfaces where D2000 KOM process can listen, can be entered). This is true for protocols:
- ALYA VT200
- DNP3
- Microtel 700
- Remia E3
- Remia KME
In other communication protocols, this is an IP address of a partner computer, with which D2000 KOM process communicates. This is true for protocols:
Primary server - Port
Either the number of UDP port on which D2000 KOM process should listen on or the number of UDP port on which a partner computer listens (see the description of parameter Primary server - Host).
Use Backup server
If this option is not selected, D2000 KOM process does not work with backup IP address/port and the line works without redundancy.
Backup server - Host
Backup IP address or network name of a computer. Depending on a specific communication protocol, it may be IP address of a computer where D2000 KOM process is running .
Backup server - Port
Either the number of a backup UDP port on which D2000 KOM process should listen on or a backkup number of UDP port on which a partner computer listens (see the description of parameter Backup server - Host).
Currently, the backup server parameters are supported in the protocols SNMP, Microtel 700 and Terminal LFC (IEC 870-5).
Related pages: