Connecting to dynamic view

Some graphic objects are dependent on the value of the connected objects and can change their shape. For the graphic objects, the palette Connect object contains extra parameters of dynamic view - the tab Dynamics.

Draw the dynamic part only

If the option is checked, there will be redrawn only the part of the object, that corresponds to the last change of the connected object.

Min. / Max.

When the value of the connected object is within the interval, the size of the graphic object can be changed.

Direction

Selection of a dynamic drawing direction:

• From center
• To center
• From center horizontally
• From center vertically
• Left to right
• To to bottom
• Right to left
• Bottom to top

Cancel dynamic drawing

Cancelling of defined settings for dynamic drawing of the graphic object.

Connecting to dynamic view can be used for graphic objects of the following types: line, multiline, arc, 3-point arc, rectangle, polygon, circle, ellipse, 3D button, 3D frame and cube.

Dynamic view can be used only for D2000 system objects, which get either integer or real values.

Note: Graphic objects of the types Line, Multiline, Arc and 3-point arc can be used only if their width is at least 2 pixels.