D2000 CNF, D2000 HI, and D2000 GrEditor can also be run against a remote server. It is necessary to enter one of the following startup parameters during startup: - Parameter /S<name_or_IP_address> - connection to the server. The server name or IP address is entered, e.g. /S172.16.0.1 or /Smyserver. If the server is available via two independent networks, it is possible to specify two IP addresses separated by comma (e.g. /S172.16.0.1,172.17.0.1) - a redundant TCP connection is used for the connection.
- Parameter /RD<name_of_RD_group> - connection to an active D2000 Server within a redundant group. The name of the redundant group specified by the GroupName parameter (e.g. /SMESRDMES) is entered. The name is case-sensitive. The connection to the redundant group is performed using multicasts, so this parameter is only applicable on the network segment where the D2000 Servers are located (or requires routers to be configured to support multicast routing).
- Parameter /RF<name_of_RD_group> - connecting to an active D2000 Server within a redundant group. The name of the redundant group specified in the registries is entered - more information here.
|