...
- LNVariableName je meno logického uzla (Logical Node). Meno môže byť ľubovolné, napr. LLN0, Obj1XCBR1, Obj2XSWI1
- FC je funkčné obmedzenie (Functional Constraint). Tabuľka definovaných funkčných obmedzení je uvedená nižšie.
- LNDataName je meno Dátového objektu (Data ObjectDataObject). Meno môže byť ľubovolné, norma obsahuje odporúčané pravidlá pre menné konvencie.
- AttributeName je meno atribútu Dátového objektu. Tabuľka bežných atribútov je uvedená nižšie.
- subDataAttributeName je meno subatribútu Dátového objektuatribútu Dátového podobjektu (SubDataObject). Tabuľka bežných atribútov je uvedená nižšie.
Norma udáva nasledujúce menné konvencie pre jednotlivé komponenty referencie:
...
Mená atribútu Dátového objektu alebo Dátového podobjektu sú definované v ISO/IEC IEC 61850-7-3 a nasledovná tabuľka obsahuje iba najbežnejšie:
| Názov atribútu | Popis |
|---|---|
| ctlModel | Specifies the control model of IEC 61850-7-2 that corresponds to the behaviour of the data. |
| d | Textual description of the data. |
| evalTm | Time window applied to interharmonic calculations. The value shall be represented in ms. |
| frequency | Nominal frequency of the power system or some other fundamental frequency in Hz. |
| instMag | Magnitude of a the instantaneous value of a measured value. |
| ldNs | Logical device name space. |
| mag | Deadbanded value. Shall be based on a dead band calculation from instMag. |
| numCyc | Number of cycles of power frequency, which are used for harmonic, subharmonic and interharmonic calculations. |
| numHar | Number of harmonic and subharmonics or interharmonic values that are to be returned as the value attribute. |
| phsAHar, phsBHar, phsCHar | This array shall contain the harmonic and subharmonics or interharmonic values related to phase A (resp. B, C). |
| phsABHar, phsBCHar, phsCAHar | This array shall contain the harmonic and subharmonics or interharmonic values related to phase A to phase B (resp. B to C, resp. C to A). |
| q | Quality of the attribute(s) epresenting the value of the data |
| setCharact | This attribute shall describe the curve characteristic. |
| setMag | The value of an analogue setting or set point. |
| stVal | Status value of the data |
| swRev | SW-revision |
| t | Timestamp of the last change in one of the attribute(s) representing the value of the data or in the q attribute. |
| units | Units of the attribute(s) representing the value of the data (ISO/IEC IEC 61850-7-3 Annex A) |
| vendor | Name of the vendor. |
Data Type
Typ hodnoty, zoznam možných typov:
...