...
Supported device types and versions
...
The protocol supports the communication with with ELCOR-2, microELCOR-2, ELCORLite, miniELCOR,and ELCORLite ELCORplus devices (made by the ELGAS company ) that recalculate a gas quantity.
...
Configuration dialog box - tab „Parameters".
They influence some optional parameters of the protocol. Following The following station protocol parameters can be set:
...
| Full name | Meaning | Unit | Default value |
|---|
| Selection of device type. | ELCOR-2 or microELCOR-2 | ELCOR-2 |
| The delay between request retries in case of a communication failure. |
| 3 |
| Delay after sending the request before reading the response. | ms | 100 ms |
| Delay between response readings until it is completed. | ms | 100 ms |
| Retry count of response reading until it is completed. |
| 30 |
| Static Period of reading static - configuration data read period (microELCOR-2 only). | min | 60 min |
Hourly Archive Periodic Reading | A period for the reading of hourly archives (0-60 min). Value 0 disables the reading. | min | 0 min |
| Length of 'wake-up' data sequence, which is sent before the request after a longer communication pause. | 0 .. 50 bytes | 25 bytes |
| Insert 'wake-up' data sequence before each request. | YES/NO | NO |
| Form 'wake-up' data sequence from the specified characters. | 0 .. 255 | 255 |
| Group source address (address of the D2000 KOM process). | 0 .. 65535 | 0 |
| Source address (address of the D2000 KOM process). | 0 .. 255 | 0 |
| Full Debug | A high level of communication tracking, the received values of I/O tags and other debug information is shown. | YES/NO | NO |
...
Table 2 contains the list of the main parameters of the device.
Tables 3 to 8 contains the list of variable configuration and informative data according to the parameter type. DESC(ind) parameter represents the common data of all parameters. It describes the quantity. The current value of quantity can be acquired by the configuration of the I/O tag with numerical address - index ind (number from 1 and higher). To find out the technical units - configure text of I/O tag with address UNIT(ind).
...