Porovnávané verzie

Kľúč

  • Tento riadok sa pridal
  • Riadok je odstránený.
  • Formátovanie sa zmenilo.

...

KeywordFull nameDescriptionUnitDefault value

Kotva
did
did
DID

Device ID

This parameter is not used for the Honeywell C-Bus line. For other line types, it has a similar meaning as the "Device ID" parameter on the Honeywell C-Bus line: it is the C-Bus Id assigned to the D2000 KOM process. It must be an unused number between 1 and 30 reserved for the D2000 KOM process on the C-Bus network.

1-3030

Kotva
br
br
BR

Baud Rate

This parameter is not used for the Honeywell C-Bus line. For other line types, it has a similar meaning as the "Baud Rate" parameter on the Honeywell C-Bus line: it is the C-Bus baud rate, supported baud rates are 4800, 9600, and 19200 Bd.
Note:
for Line ModeDirect and a Serial line, the parameter must match the communication speed configured on the line.

baud9600

Kotva
lm
lm
LM

Line Mode

Mode of communication with C-Bus:

  • ISA card - uses ISA card KMFB02 (obsolete)
  • KPX02 - use of KPX02 communication computer
  • Direct - direct communication via RS-485 serial interface
ISA card
KPX02
Direct
Direct

Kotva
kl
kl
KL

KOM Latency

The parameter allows "tuning" of time parameters. A positive value decreases the wait before sending a message, a negative value increases the wait. Reducing the wait can compensate for the slowness of the communication computer.

0.1 ms0

Kotva
pr
pr
PR

Periodic Reads

The parameter activates the explicit periodic reading of the values of the I/O tags. By default, Honeywell devices send values spontaneously upon change.

-NO

Kotva
di
di
DI

Debug Input

Debugging messages for input data. The parameter is a bitmask, meaning of individual bits is as follows:

  • 1.bit - debugging of received data - priority task handling RS-485 interface (for Line ModeDirect)
  • 2.bit - debugging of received packets with correct CRC - priority task handling RS-485 interface (for Line ModeDirect)
  • 3.bit - debugging of received packets with correct CRC - line service task
  • 4.bit - debugging of received values - line service task
  • 5.bit - debugging of analyzed packets - line service task
-0

Kotva
do
do
DO

Debug Output

Debugging messages for output data. The parameter is a bitmask, meaning of individual bits is as follows:

  • 1.bit - debugging of sent data - priority task serving RS-485 interface (for Line ModeDirect)
  • 2.bit - debugging of special packets - priority task serving RS-485 interface (for Line ModeDirect)
  • 3.bit - debugging of sent data - line service task
  • 4.bit - debugging of composed requests - line service task
  • 5.bit - debugging of reading the list of points - line service task
-0

Kotva
komunikacna_stanica
komunikacna_stanica
Communication station configuration

...